Let’s discuss the question: how much is a ford 9n tractor worth. We summarize all relevant answers in section Q&A of website Achievetampabay.org in category: Blog Finance. See more related questions in the comments below.
Are Ford 9N tractors good?
8n and 9n Ford tractors are very dependable machines and you can still find a lot of replacement parts despite being more than half a century old. But overall, the 8n is the better option when considering between the two.
What years did Ford make the 9N tractor?
The Ford N-series tractors were a line of farm tractors produced by Ford between 1939 and 1952, spanning the 9N, 2N, and 8N models. The 9N was the first American-made production-model tractor to incorporate Harry Ferguson’s three-point hitch system, a design still used on most modern tractors today.
8N, 9N, 2N, WHAT’S THE DIFFERENCE?
Images related to the topic8N, 9N, 2N, WHAT’S THE DIFFERENCE?
How many HP does a Ford 9N have?
| Ford 9N Power | |
|---|---|
| Drawbar (claimed): | 12.68 hp 9.5 kW |
| Belt (claimed): | 20.29 hp 15.1 kW |
| Plows: | 2 (14-inch) |
| Drawbar (tested): | 16.31 hp 12.2 kW |
How fast does a Ford 9N go?
11 mph @ 2000 rpm (full throttle) for standard 3rd gear. 18 mph @ full throttle if you have a step up tranny.
Does a Ford 9N have a PTO?
Yes you must have PTO engaged and cluch out to raise lift. The hyd pump does not run with out PTO. A little tricky to use some times but you will get used to it.
How do you tell an 8N from a 9N?
You are definitely looking at an 8N tractor if: The rear wheel is dished, with a large nut in the center surrounded closely by 8 more lug nuts. In contrast, both the 9N and 2N models have a flat rear wheel with a ring of 6 lug nuts further out. There’s a 4-speed transmission.
What does a Ford 9N weight?
I noticed in the Nebraska test the tractor weighed 3375 including 151 lbs. of calcium chloride in each rear tire. However, in the Ford N Series tractor book it said the 9N weight including gas , oil and water is 2410.
How do I identify a Ford 9N tractor?
The best way to identify a tractor is by the serial number. Serial numbers on the 9N-2N and 8N tractors are located on the left side of the engine block, just below the head and behind the oil filter.
Ford 9N General Information: Ford N series tractors
Images related to the topicFord 9N General Information: Ford N series tractors
What does a live PTO mean?
Live (two-stage clutch)
A live PTO works with the use of a two-stage clutch. Pressing the clutch half-way will disengage the transmission while pressing it fully will disengage the transmission and the PTO. This allows the operator to slow down or change gears while the PTO is still operating.
How much can a Ford 9N lift?
The repair manual lists a lift weight of 975 lbs for a 7′ disk harrow. Sounds like the lift is behaving normally. Since the 9N has no position control like the 8N, you need a “Zane Thang” to control the position of your mower.
What is the difference between a 8N and a 9N Ford tractor?
The 8N Ford is a little higher than the 9N Ford tractor. The 9N Ford tractor is three-speed whereas the 8N Ford tractor has a four-speed transmission. The nine had feet and the nine had running panels. The 8N Ford tractor is on the right side with the two brakes and the 9N Ford tractor is on the left.
What color is a 9N Ford tractor?
There is only one dark grey, two medium gray, and one light gray. There are five types of gray: Dark Gray, medium Gray, medium Gray, and light Gray. The 9N/2N is the dark gray for the 9-N/NaA series, and the NAA and Thousand are the light grays for the Thousand series.
Does a Ford 8N have a live PTO?
Supporting Member. One disadvantage of the Ford N’s was, they are not Live pto and Live hydraulic. When you push the clutch in, they stop. The mower stops mowing and if it was raised, it lowers to the ground.
How do you engage PTO on a Ford 9n?
Lever on the left is for the PTO. Clutch pedal needs to be all the way down to engage the PTO, then slowly release pedal and PTO should start spinning.
What size is a Ford 9n PTO shaft?
Part Notes
Notes: Shaft is 30 7/8″ length by 1 3/8″ diameter w/6 splines, can be used to convert from 1 1/8″ to 1 3/8″, includes PTO housing, collar with set pin, snap ring, front PTO bearing, front PTO sleeve, PTO seal – all preassembled.
Should You Buy An 8N Ford Tractor
Images related to the topicShould You Buy An 8N Ford Tractor
How much is an 8N tractor worth?
In the United States a used Ford 8N tractor is typically priced between $3,250 and $3,450. Variation in price can be due to a number of factors including age, condition, location, and specifications.
What is the firing order on a Ford 9N tractor?
1243 is the correct firing order for a 9N engine. Suggest you check your spark plug wire continuity.
Related searches
- 1939 ford 9n for sale on craigslist
- how much does a ford tractor cost
- ford 9n attachments
- how much is my ford worth
- 1941 ford 9n tractor
- ford 9n parts
- how to drive a ford 9n tractor
- ford 9n for sale craigslist
- how much is an old ford tractor worth
- is a ford 9n a good tractor
- ford 9n tractor hp
- 1940 ford 9n tractor
- ford 9n tractor prices
Information related to the topic how much is a ford 9n tractor worth
Here are the search results of the thread how much is a ford 9n tractor worth from Bing. You can read more if you want.
You have just come across an article on the topic how much is a ford 9n tractor worth. If you found this article useful, please share it. Thank you very much.
